Home EtherSound card for Studer consoles- Support

EtherSound card for Studer consoles- Support

This card is designed to fit into the Studer D21m I/O system rack for use with the Studer OnAir 3000 console, and is also compatible with Studer flagship Vista series and routing systems.

The EtherSound firmware of the card can be updated (if required) through the ESFirmwareUpdater application.

The card is lso supported by EScontrol, the Digigram application allowing the setup and management of EtherSound networks.

In case Digigram  AQONDA products are used in the EtherSound network, it is useful to run D21m-ES Configuration Tool  to configure the card in order to enable the remote control of AQONDA devices from a Studer or SoundCraft console. This application enables a special mode of the card, where it emulates a MADI stagebox and then route the preamp control commands to AQONDA devices.

User manuals